How to Attach a Dragonne or Sangle to Your TimeLens
By TIME LENS | Published: 2026-10-15
Category: How-to Guides
A step-by-step guide to fitting a Dragonne wrist strap or Sangle shoulder strap to your TimeLens gear, with the checkpoints and mistakes that matter most.
Quick answer
Thread the strap loop through your TimeLens attachment point, pass the strap back through its own loop, and pull it snug before you let go of the camera. A Dragonne sits on your wrist and stays compact; a Sangle crosses your body and needs a length check before you walk anywhere. Either way, tug-test the connection with light pressure before the gear leaves your hands.
Before you start: what to check on the strap and the camera
Lay the strap flat and look at the webbing or cord for fraying, stiff creases, or a loop that has lost its shape. Check the camera or bag attachment point too: it should be solid, not loose or rotating freely. If the attachment point spins or feels slack, fix that first — no strap technique compensates for a weak anchor.
Work over a soft surface such as a bed or a folded towel. If you are fitting a wrist strap, keep the camera body resting on that surface until the loop is fully tightened, so a slip does not become a drop.
How to thread and lock the strap loop
Push the thin end of the strap through the attachment point from the side that gives you the cleanest exit. Bring it back through the strap's own loop or buckle to form a self-tightening connection. Pull the tail until the knot sits flat against the anchor — a twisted or half-formed loop is the most common reason a strap feels secure but slips under load.
Once tightened, give the camera a gentle tug while holding the strap, not the body. If the loop shifts or the tail creeps, undo it and re-thread rather than adding tape or a second knot.
Setting length for wrist and shoulder carry
For a Dragonne, the strap should sit around your wrist with just enough slack to slide on and off, but not so much that the camera can swing free. For a Sangle, adjust it so the camera rests at hip or lower-chest height when worn across the body, then walk a few steps and turn side to side to confirm it does not ride up into your neck.
Length is personal, so adjust in small increments and re-check after each change. A strap that feels fine standing still can behave differently once you are moving.
Step-by-step: fitting your TimeLens strap
- 1. Inspect the anchor point: Check the camera or bag attachment point for looseness, rotation, or sharp edges before threading anything through it. If the anchor moves or feels weak, stop and address that first.
- 2. Thread the strap through the anchor: Pass the thin end through the attachment point from the cleanest side, then back through the strap's own loop to create a self-tightening connection. A loop that sits flat against the anchor is the goal; a twisted loop is the mistake to avoid.
- 3. Tighten and tug-test: Pull the tail until the knot is snug, then hold the strap and give the camera a gentle tug to confirm the loop does not creep. If it shifts, re-thread rather than adding extra knots or tape.
- 4. Set the length for your carry style: For a Dragonne, allow just enough slack to slide your wrist in and out. For a Sangle, adjust until the camera rests at hip or lower-chest height across the body. Re-check the length after a few steps, not just while standing still.
- 5. Do a final walk-and-turn check: Walk a short distance and turn side to side to confirm the strap stays where you put it and does not ride into your neck or swing loose. Adjust in small increments until the strap feels stable in motion.
TimeLens strap options that fit this process
- Sangle Cream Sorbet: Sangle Cream Sorbet is adjustable to your size and installs in about 30 seconds with a clip-and-go connection. If you want a shoulder strap you can move between bags quickly, the clip system and adjustable length remove most of the threading guesswork.
- Dragonne Jaune: Dragonne Jaune is compact and light, and works with both phone and camera. A light wrist strap suits short shooting sessions where a full shoulder strap would be more hardware than you need.
- Dragonne Kaki: Dragonne Kaki is compact and light, and works with both phone and camera. If you already carry TimeLens gear in Kaki, matching the strap keeps your kit visually consistent without changing how it attaches.
